NXT MMX V2 motor rotation problem
 Hardware Related   Started by Normand Ballard   2016-01-08 06:10:35 -05:00   Comments: 3    Viewed: 660

  1. I am a new member, I just receive my first motor multiplexer for my lego EV3 brick.
    I downloaded the associated block to drive the board for my two motors and i builted a small program to test it, I found I can control my motor only in reverse direction and the braking mode does not work. I tried other motors, wires, and swap motor port M1 and M2 but it always do the same problem, I finally found if I program a forward direction for one turn and I help the motor to start turning, it will continu very slowly the full turn and than stop without brakink.
    I think my new board is not operating properly!, any idea to help me running my two motors properly with my new multiplexer?

    Regard's
    Normand Ballard
    Normand Ballard, 2016-01-08 06:10:35 -05:00
  2. Michael Giles
    Michael Giles Member Staff Member Richmond, VA
    What is the power you are applying to the green connector of the NXTMMX?
    Michael Giles, 2016-01-08 10:46:41 -05:00
  3. I Michael,
    I am using a 9 volts power supply 2 Amps.
    it goes fast on reverse direction!
    Normand Ballard, 2016-01-08 11:30:23 -05:00
  4. (You must log in or sign up to post here)

Log in | Sign up
Tems & Conditions!
Help!