NXTMMX-v2 unresponsive
 NXT and EV3   Started by Jake Roos   2018-05-10 06:08:14 -04:00   Comments: 1    Viewed: 82

  1. Jake Roos
    Jake Roos Member
    Hi there,

    I have powered up my new multiplexer, and have got it to operate two servos, but now it has stopped. I am using it with NXT 2.0. I have checked the power supply to the multiplexer - all okay. The sensor I've connected to its sensor port still works (well, the lamp turns on and off). The programs that include instructions to the multiplexed servo run, they just skip over the NXTMMX block. It is inexplicable, as it was working fine earlier today, though I did need to put each NXTMMX block inside a loop with a count of 1 exit condition to get it to behave. To begin with the servos connected to it just kind of convulsed randomly.

    I really need the NXTMMX to work and work reliably for this upcoming show. Help please!

    Jake
    Jake Roos, 2018-05-10 06:08:14 -04:00
  2. (You must log in or sign up to post here)

Log in | Sign up
Tems & Conditions!
Help!